TUBULURE D'ADMISSION 900R


This document presents installation instructions for your aluminium intake manifold. Please take the time to read carefully to ensure a successful installation. Proceed as follows:

 

  • Remove the factory plastic intake manifold. Remove the following:
    • Plastic housing secured on the throttle body with 4 screws.
    • Map sensor
    • Flange O-rings (3 total)
  • Put aside the throttle body with the coolant lines still attached to it.
  • Remove the engine loom securing clip on the valve cover which is located on the clutch side. It is secured by a M6 torx screw. This is done in order the provide more wire lenght to the throttle body and a better angle for routing the loom.
  • Remove a section of insulation tape on the throttle body loom to increase the lenght available going the the throttle body.  Be careful not to damage the wires when using any kind of cutting tool. Once enough insulation material is removed and there is more lenght available before the "Y" intersection on the loom, simply insulate the loom again with good quality electric insulation tape. Please refer to the picture below.

 

 

  • Install the 3 factory O-rings on the aluminum intake flange. Simply trim the centering rubber tabs on the O-ring to end up with a round O-Ring.
  • Install the intake manifold on the engine using your original M6 bolts. Do not torque more than 11 newton.
  • Install the injectors and fuel rail. Do not reuse the factory injector retaining clips as this will prevent the injectors for rotating freely and will not allow best positionning of the injectors to minimize connector interference..
  • Install your factory Map sensor on the clutch side of the intake. The boost sensor is no longer used with this intake which is intended to be used with an aftermarket MaxxECU or similar standalone engine management system.
  • Now is the time to install injector extension wires. Route to avoid chaffing and excessive tension.
  • Use the provided 5/16" fuel hose extension between the fuel filter and the fuel rail. Simply remove the factory rubber hose in this area and replace with the longer hose provided with your kit. 2 clamps are included to secure the hose on the fuel filter and on the fuel rail.
  • The throttle body can now be mounted on the intake manifold. Refer to the picture below for the proper orientation. Use the 4 M6 bolts provided with your kit as well as the 2" O-ring between the throttle body and the flange

  • Connect the throttle body electrical connector. Ensure the connector is properly routed to avoid pulling and excesive tightness. Use zip-ties to secure the connector loom and prevent it from vibrating loose. 
  • Plug the port on the muffler side of the intake manifold if you are not using a blow-off valve or a boost gauge. Use this port ortherwise for any of these add-on's.
  • Install the silicone 90 degree coupler on the throttle body as well as the aluminum elbow so that your final piping position looks like the picture below.
  • Connect your charge tube on the aluminum elbow and secure with the T-bolt clamp provided with your kit.